Tumblelog by Soup.io
Newer posts are loading.
You are at the newest post.
Click here to check if anything new just came in.

November 26 2011

action68

Great Idea to test by tilting.

But I am not too sure what the benefits of rapid deceleration would be. I mean you have to handle that wobbly filament and treating it harder could cause problems.. (Well maybe treat it real hard so it does behave like a solid?)

A seperate acceleration value for slowing down the extruder (a lower one) before retract could be beneficial..
     

November 08 2011

action68
I think it gets a bit simpler as we can convert only those cases where the segment length is equal.  As the STL s are created with equal segment lengths if they are describing an arc we can first check if the segment lengths are the same, if that is the case go for the arc calculation.  So we have a special case of circumscribing arc. As the triangles are symmetric.
Action68
Older posts are this way If this message doesn't go away, click anywhere on the page to continue loading posts.
Could not load more posts
Maybe Soup is currently being updated? I'll try again automatically in a few seconds...
Just a second, loading more posts...
You've reached the end.

Don't be the product, buy the product!

Schweinderl